BEST-121體積表面電阻率測試儀
一、符合標準及適用范圍:
*符合國家標準GB1410-2006固體電工絕緣材料絕緣電阻、體積電阻系數和表面電阻試驗方法,ASTM D257 絕緣材料的直流電阻或電導試驗方法 等標準要求。
體積表面電阻率測試儀配有不同的測量電極(夾具)可以測量不同材料(固體、粉體或液體)的體積電阻率和表面電阻率或電導率。適用于橡膠、塑料、薄膜、及粉體、液體、及固體和膏體形狀的各種絕緣材料體積和表面電阻值的測定。本儀器除能測電阻外,還能直接測量微弱電流。
二,主要特點:
電阻測量范圍寬 1×104Ω ~1×1018Ω
電流測量范圍為 2×10-4A ~1×10-16A
體積小,重量輕,準確度高
電阻,電流雙顯示
性能好穩定,讀數方便
所有測試電壓(10V/50V/100/250/500/1000V) 測試時電阻結果直讀,免去老式高阻計在不同測試電壓下或不同量程時要乘以系數等使用不便的麻煩,使測量超高電阻就如用萬用表測量普通電阻樣簡便。既能測超高電阻又能測微電流
三,技術指標:
1,電阻測量范圍: 0.01×104Ω ~1×1018Ω。
2,電流測量范圍為: 2×10-4A~1×10-16A
3,顯 示 方 式:數字液晶顯示
4,內置測試電壓: 10V ,50V,100V,250,500,1000V
5,基本準確度:1% (*注)
6,使用環境: 溫度:0℃~40℃,相對濕度<80%
7,機內測試電壓: 10V/50V/100/250/500/1000V 任意切換
8,供電形式: AC 220V,50HZ,功耗約5W
9,儀器尺寸: 285mm× 245mm× 120 mm
10,質量: 約5KG
四、典型應用:
1,測量絕緣材料電阻(率)
2,測量防靜電材料的電阻及電阻率
3,測量計算機房用活動地板的系統電阻值
4,測量防靜電鞋,導電鞋的電阻值
5,光電二極管暗電流測量
6,物理,光學和材料研究
五、標準配置:
1,測試儀器:1臺
2,電源線:1條
3,測量線:3根(屏蔽線,測試接線,接地線)
4,使用說明書:1份
體積表面電阻率測試儀
符合標準及適用范圍:
Meet the standards and scope of application:
*符合國家標準GB1410-2006固體電工絕緣材料絕緣電阻、體積電阻系數和表面電阻試驗方法,ASTM D257 絕緣材料的直流電阻或電導試驗方法 等標準要求。
In full compliance with national standards GB14102006 solid electrical insulation materials insulation resistance, volume resistivity and surface resistivity test method, ASTM D257 insulation material of DC resistance or conductance of test method standards requirements.
本儀器配不同的測量電極(夾具)可以測量不同材料(固體、粉體或液體)的體積電阻率和表面電阻率或電導率。適用于橡膠、塑料、薄膜、及粉體、液體、及固體和膏體形狀的各種絕緣材料體積和表面電阻值的測定。本儀器除能測電阻外,還能直接測量微弱電流。
This instrument can measure the volume resistivity and surface resistivity or conductivity of different materials (solid, powder or liquid) with different measuring electrodes. Suitable for the measurement of the volume and surface resistance of rubber, plastics, film, powder, liquid, and solid and paste shapes. In addition to the measurement of resistance of the instrument, but also can directly measure the weak current.
二,主要特點
Two, the main features
電阻測量范圍寬 1×104Ω ~1×1018Ω
Resistance measurement range x 104 x 1 x 1018 x 1
電流測量范圍為 2×10-4A ~1×10-16A
The current measurement range is 2 * 10-4A ~ 1 * 10-16A
體積小,重量輕,準確度高
Small in size, light in weight and high in accuracy.
電阻,電流雙顯示
Resistance, current dual display
性能好穩定,讀數方便
Good performance and stable, easy to read
所有測試電壓(10V/50V/100/250/500/1000V) 測試時電阻結果直讀,免去老式高阻計在不同測試電壓下或不同量程時要乘以系數等使用不便的麻煩,使測量超高電阻就如用萬用表測量普通電阻樣簡便。既能測超高電阻又能測微電流
All the test voltage (10V/50V/100/250/500/1000V) to test the resistance results in reading, replacing the old high resistance meter in different test voltage or different scale to multiplied by the coefficient of use inconvenience trouble, enable the measurement of ultra high resistance as the multimeter is used to measure the general resistance of samples is simple. Not only can measure high resistance and micro current
三,技術指標
Three, technical indicators
1,電阻測量范圍: 0.01×104Ω ~1×1018Ω。
1, resistance measurement range: 0.01 * 104 ~ 1 * 1018.
2,電流測量范圍為: 2×10-4A~1×10-16A
2, the current measurement range is: 2 * 10-4A ~ 1 * 10-16A
3,顯 示 方 式:數字液晶顯示
3, explicit formula: digital liquid crystal display
4,內置測試電壓: 10V ,50V,100V,250,500,1000V
4, built-in test voltage: 10V, 50V, 100V, 2505001000V
5,基本準確度:1% (*注)
5, basic accuracy: 1% (* Note)
6,使用環境: 溫度:0℃~40℃,相對濕度<80%
6, the use of the environment: temperature: 0 degrees Celsius to 40 degrees Celsius, the relative humidity of <80%
7,機內測試電壓: 10V/50V/100/250/500/1000V 任意切換
7, the machine test voltage: 10V/50V/100/250/500/1000V arbitrary switching
8,供電形式: AC 220V,50HZ,功耗約5W
8, the form of power supply: 220V AC, 50HZ, power consumption is about 5W
9,儀器尺寸: 285mm× 245mm× 120 mm
9, instrument size: 285mm * 245mm * 120 mm
10,質量: 約5KG
10, quality: about 5KG
典型應用
Typical applications
1,測量絕緣材料電阻(率)
1, measuring the resistance of insulating materials (rate)
2,測量防靜電材料的電阻及電阻率
2, measuring the resistance and resistivity of antistatic materials
3,測量計算機房用活動地板的系統電阻值
3, measuring the system resistance value of the computer room floor
4,測量防靜電鞋,導電鞋的電阻值
4, measure the anti-static shoes, the resistance value of conductive shoes
5,光電二極管暗電流測量
5. Dark current measurement of photodiode
6,物理,光學和材料研究
6, physics, optics and materials research
標準配置:
Standard configuration:
1,測試儀器:1臺
1, test equipment: 1 sets
2,電源線:1條
2, power cord: 1
3,測量線:3根(屏蔽線,測試接線,接地線)
3, measuring line: 3 (shielding wire, test wiring, grounding wire)
4,使用說明書:1份
4, the instruction manual: 1 copies