帶式真空干燥機

一、工作原理及應用范圍介紹 

Introduction of Working Principle and Scope of Application

液態物料在真空狀態下經圓筒形夾套加熱產生的輻射熱以及輸送鋼帶承力夾套板加熱產生的傳導與輻射熱綜合作用下，通過調節烘干溫度以及網帶的運行速度讓物料從進料端輸送到出料端過程中很快的被烘干脫水達到工藝要求，然后在刮料機構清理下將干燥后的物料刮下經專門的出料機構排出，從而達到烘干之目的。廣泛應用于醫藥、食品、化工、生物工程等行業的低溫脫水烘干。

    Under the combined action of the radiant heat produced by heating of cylindrical jacket and the conductive and radiant heat produced by heating of transmission steel belt bearing jacket plate, liquid material in the vacuum state is conveyed from the feed end to the discharge end through the adjustment of drying temperature and running speed of wire belt and can be dried and dehydrated quickly in the course and meet the technological requirements. Subsequently, the dried material is scraped by the scraper mechanism and discharged via the special discharging mechanism, so that the drying purpose is achieved. The drier is widely applied for dehydration and drying at low temperature in such industries as medicine, food, chemical engineering and bioengineering.

二、特點 Characteristics

1. 物料在噴霧機構噴霧作用下均勻鋪撒于輸送干燥板上。鋪料以及干燥均勻，料層厚薄可控。

2. 內、外加熱，干燥效率高。

3. 真空干燥物料在相對低溫下干燥、破壞性小。

1.The material is uniformly spread on the conveying and drying plate under the spray action of spraying mechanism. The material is spread and dried uniformly, and the thickness of material layer is controllable.

2.Internal and external heating ensures high drying efficiency.

3.Vacuum drying material is to dry at relatively low temperature, with low destructiveness.

三、技術參數（下表中數值僅供選型時參考）

Technical parameters (the values in the table below are for reference in type selection only)

四、工藝流程圖Process flow diagram