RFS氣動黃銅絲口閘閥RFS yellow wire port pneumatic valve：
RFS pneumatic brass wire port valve can only be fully open and fully closed, and is not suitable for adjusting the throttle. Brass wire port valve has two sealing surface, the two most commonly used sealing surfaces wedge gate valves forming wedge, wedge angle with the valve parameters vary, usually 5o. Wedge gate valve can be made into a whole, called the rigid gate; can also be made to produce small quantities of deformation gate in order to improve its process, to make up the sealing surface angle deviations arising during processing, this gate board called the flexible gate.
RFS氣動黃銅絲口閘閥只能作全開和全關，不適合作調節和節流。黃銅絲口閘閥有兩個密封面，zui常用的楔式閘板閥的兩個密封面形成楔形，楔形角隨閥門參數而異，通常為5o。楔式閘閥的閘板可以做成一個整體，叫做剛性閘板；也可以做成能產生微量變形的閘板，以改善其工藝性，彌補密封面角度在加工過程中產生的偏差，這種閘板叫做彈性閘板。
RFS氣動黃銅絲口閘閥適用工況：
公稱壓力：1.6MPa
工作介質：水、油、汽
工作溫度：t≤100℃
管螺紋符合ISO228標準
RFS pneumatic valve brass wire mouth conditions apply:
Nominal pressure: 1.6MPa
Working medium: water, oil, gas
Working temperature: t≤100 ℃
Standard Pipe thread to ISO228
RFS氣動黃銅絲口閘閥具有以下優點；
1、流體阻力小，密封面受介質的沖刷和侵蝕小。
2、開閉較省力。
3、介質流向不受限制，不擾流、不降低壓力。
4、形體簡單，結構長度短，制造工藝性好，適用范圍廣。
結構尺寸：
注意事項：本文中所有文字、數據、圖片均只適用于參考，氣動黃銅絲口閘閥性能參數、結構尺寸參數、價格等詳情，請的銷售、技術工程師，：/64966685。
